One of the top two most popular models, if not the most popular is the hip roof framing. not only he added architectural lines in the design of a house, but also offers more protection elements on the walls, windows and doors when I Framed with a generous overhang. italso lends itself more to the structural integrity of a home with four tie pin corners and walls of the structure.
A hip roof is a bit more complex than for framing a gable roof. Furthermore a peak map,only the rafters gable (all beams of equal length) as its only components. the components of a hipped roof is the peak council, beams, hips and jack rafters.
The hip roof does not always have a peak advice. If the building is a square with four walls having the same length, there is no roof ridge and resemble a pyramid.
When cutting beams hip and jack, their lengths can be determined using a calculator or table book beam as "The entire body Rafter Framer." length peak can be determined by subtracting the width of the building length. to for example, if the building is 30 x 24, the peak is six feet long. If the board crest
is a "thick (which is usually the case), then half" should add half the ridge length. This is because all beams half the thickness of the rib are shortened or 3/4 ". This allows the top of the beams to be aligned with the top of the peak in each end.
When a hipped roof, beams always fires. This will place the peak its proper location. This part of the roof is framed as a gable roof, but the similarity it stops there.
Start by nailing the beams from one side of the ridge at each end. Now raise the ridge and nailing two gallons on the other side of the opposite edge to the first two beams. one time
is done, push up the ridge to the mouth reductions bird doing very tight to the walls of each side of the building. These gallons now be nailed to the wall in a corresponding locations on the ridge. Now nail the two beams at the end of the center
walls and the ends of the edge. This will lock the song in its exact location.
The rest of the beams can be nailed to the wall and the crest of the ridge. the following parts to be fitted are the four beams hip. These are fixed on the outside corners of walls and buildings at the intersection made by the end and the first joint beam which are located at the crest. With the hips and beams in place, it is easy see why this makes such a strong and solid roof.
With the hips to the rafters cat can be installed. Before nailing the first beams jack, a chain must be run from the plumb cut on the hip just above the birdsmouth. This can be done by driving a nail in the center of the hip aforementioned locations. Tie the string to a nail, pull it tight, and secure it with another nail. this one is to ensure the hip is straight when taking girder installation. actuators are stuck in the chain must be stored in the center of the hip. To help keep the hip Chevron right, beams cat should be nailed in pairs, first one side of the hip,
and his companion on the other.
This process continues throughout hip rafter until all jack beams are installed on both sides of the hip. Remove the string and repeat this procedure in the remaining three hips to complete the definition of cover. Neck ties and fascia must be installed before the roof can be wrapped but These are the basic steps in developing a hip roof framing.
No comments:
Post a Comment